Asante FriendlyShare Manual do Utilizador descarregar pdf (Página 17)

User’s Manual 17

Chapter 3. Configuring DHCP for Macintosh

Computers

In this chapter you’ll be configuring each computer in your network to automati-

cally receive its IP network address from the router. The router functions as a

DHCP (dynamic host configuration protocol) server for up to 253 network de-

vices on your LAN.

Note:

Please refer to Chapter 4 to configure Microsoft Windows computers.

Tip

: Before changing your TCP/IP network settings, record the settings on a

separate piece of paper. If you have one computer directly connected to a cable

or DSL modem service, be sure to fill out the appropriate table on page 3 or 4 in

the Quick Start Guide.

3.1 Setting DHCP for Apple Macintosh Computers

Your Mac should have a built-in Ethernet port or a previously installed Ethernet

adapter.

Note: If you have previously installed

Asanté FriendlyShare (or other Internet

sharing software) on any of your Macs,

you must remove it.

1. Open the TCP/IP control panel.

2. From

Connect via

:, choose the

built-in Ethernet port or the

Ethernet adapter that is installed in

your system.

3. From

Configure

:, choose

Using

DHCP Server

. The Asanté router will automatically assign all the TCP/IP

parameters for your system if DHCP server is enabled on the router.

4. Optional: Select Edit/User Mode/Advanced. Click on the

Options…

button

to verify that the TCP/IP is Active.

5. Close the dialog box. When prompted, save changes to the current configu-

ration.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 83 84

Sem comentários

Asante FriendlyShare Manual do Utilizador Página 17